Display
Referring to the following table for the illustration of each item on the image page:
|
Parameters |
Function Introduction |
|---|---|
| Power Line Frequency |
60HZ flicker for NTSC mode and 50HZ flicker for PAL mode |
| Day/Night Mode |
There are several parameters associated with this mode such as Exposure Level, Maximum Exposure Time and IR-CUT Interval, etc. Night Mode: Shown in the live view based on Night Mode settings Day Mode: Shown in the live view based on Day Mode settings Auto Mode: Shown in the live view based on environment, set the sensitivity for switching Day Mode to Night Mode, or Night Mode to Day Mode Customize: Shown in the live view based on your own settings’ time to start/end Night Mode |
| Day To Night Value |
This is the sensitivity for switching Day Mode to Night Mode. When IR Light Sensor Current Value is lower than this value, it will switch Day Mode to Night Mode |
| Night To Day Value |
This is the sensitivity for switching Night Mode to Day Mode. When IR Light Sensor Current Value is higher than this value, it will switch Night Mode to Day Mode |
| IR Light Sensor Value |
The current value of the IR light sensor |
| Smart IR Mode |
With the combination of the High Beam and Low Beam,The IR LEDs technology has been upgraded to provide better image clarity and quality regardless of the object distance. Also, the Low Beam and High Beam's brightness can be adjusted manually or automatically on the basis of the Zoom ratio. Moreover, with the IR anti-reflection panel, the infrared light transmittance is highly increased. Support to set the intensity of the IR to Auto Mode or Customize to achieve the best effect. |
| Near view level |
Adjust the light intensity of Low-Beams LED light level from 0 to 100. |
| Far view level |
Adjust the light intensity of High-Beams LED light level from 0 to 100. |
| IR Strength Value |
The current value of Low-Beams LED and High-Beams LED light value |
| Outdoor/Indoor Mode |
Select indoor or outdoor mode to meet your needs |
| Corridor Mode |
There are three options available, you can select one to meet your need Off: Keep the image in normal direction Clockwise 90°: Rotate the image by 90° clockwise Anticlockwise90°: Rotate the image by 90° anticlockwise |
| Image Rotation |
There are four options available, you can select one to meet your need Off: Keep the image in normal direction Rotating 180°: Invert the image Flip Horizontal: Flip the image horizontally Flip vertical: Flip the image vertically |
| Keep Correct Aspect Ration |
With this option enabled, the camera will prevent the image from distortion when resolution ratio is changed |