3.1.5 Editing Device

1. If the device hasn't been added yet in “Device Search” interface, you can edit the device that has been activated by clicking , you can edit IP Address, Port, Netmask, Gateway and DNS by inputting the correct User Name and Password.



2. If the device has been added to “Devices Added” interface, you can edit the device by clicking the Edit button . All parameters can be edited except the Device Type. See as below:

  • Device Modify window(General camera)



  • Device Modify window(Fisheye camera)



  • Device Modify window(NVR)



The meanings of the items on the page can be referred to the table below.

Table 1. Description of the buttons
Item

Function Introduction

Device Type

Camera and NVR are available

Name

Name of the device

IP Address

If you choose IP/Domain as connection type, enter the IP address of the device here

Port

The port of the device, the default port is 80

Transfer Mode

There are two options, “Bundle Stream Mode” and “Multi-Channel Mode”

Note:
  • This function option is only available for fisheye camera.
  • The Stream Mode can not be edited for fisheye under Multi-Channel mode unless you select 1O/1P/2P.

On-board Installation Mode

There are three options, “Ceiling”, “Wall” and “Flat”

Note: This function option is only available for fisheye camera.

On-board Display Mode

There are different options for different modes:

Bundle Stream Mode---Ceiling/Flat/-Wall: 1O, 1P, 2P, 4R, 1O3R ,1P3R

Multi-Channel Mode---Ceiling/Flat: 1O, 1P, 2P, 4R, 1O3R, 1P3R, 1O1P3R

Multi-Channel Mode---Wall: 1O, 1P, 4R, 1O3R, 1P3R, 1O1P3R

Note: This function option is only available for fisheye camera.

Channel ID

This option will show the number 1 for fisheye under Bundle Stream Mode, while show current channel ID for fisheye under Multi-Channel mode

Note:
  • This function option is only available for fisheye camera.
  • You can choose other channel ID for fisheye under Multi-Channel mode. If the channel ID has been added, then there is a pop-up prompt window like “Device already exist” and switch failed; if the channel ID has not been added, then you can modify channel ID successfully.

User Name

The user name of the device, the default user name is “admin”

Password

Enter the password for the account of the device, for camera version lower than V4x.7.0.69 and NVR version lower than V7x.9.0.3, the default passwords are:

  • Network Camera: ms1234
  • NVR: ms1234

Transport Protocol

TCP and UDP are available
Note: Password must be 8 to 32 characters long.