Installation Steps

Ceiling Mount

Step 1: Drill two 6 mm holes aligned with the screw positions of the device, then insert wall plugs into the ceiling.

Note: If you need to hide the power cord inside the ceiling, drill an additional hole for the wire.

Step 2: Cut a side wire hole according to the mark on the device, and thread the power cable through the side wire hole.

Note: If the DO wiring is going to be used, please connect the DO wiring to the device, then pass it through the side wire hole.

Step 3: Fix the device to the wall plugs using the mounting screws.

Step 4: Align one edge of the T-shaped Spirit Level with either edge of the device and adjust the device until both water bubbles are centered, ensuring that the device is perfectly parallel.

Step 5: Install the silicone plugs.

Cutout Mount

Step 1: Drill a hole with a diameter of 76.3~80mm in the ceiling.

Step 2: Fix the spring clips to the device with screws.

Step 3: Cut a side wire hole according to the mark of the device, and thread the power cable through the side wire hole.

Note: If the DO wiring is going to be used, please connect the DO wiring to the device, then pass it through the side wire hole.

Step 4: Insert both spring clips vertically into the ceiling hole by hand.

Step 5: Align one edge of the T-shaped Spirit Level with either edge of the device and adjust the device until both water bubbles are centered, ensuring that the device is perfectly parallel.

Step 6: After the device is completed, install the silicone plugs.