Radios Settings

Currently our IoT camera supports three IoT frequency bands of 915M (The corresponding channel plan is US915/AU915/KR920/AS923/AS923-2), 868M (The corresponding channel plan is IN865/EU868/RU864) and 470M (The corresponding channel plan is CN470). Before buying the camera, you need to contact our sales to choose the frequency band that is supported in your country.

For example, here I choose the IoT camera with the frequency bands of 470M or reference document regional parameters for LoRaWAN, and it will show that the current channel plan is CN470 on the page.

Note: Usually you can directly use the default settings without configuring Radio Settings. If you need to customize some radio settings, you can make further settings as shown below.


Table 1.

Parameters

Function Introduction

Enable IoT

Enable/Disable the IoT function.

Channel Plan

The required Channel Plan can be selected according to the country region. For example, here I choose the IoT camera with the IoT frequency band of 915M, then it will list all the channel plans supported by this frequency band, including US915, AU915, AS923, AS923-2 and KR920, then I need to select the corresponding channel plan.

Channel Mask

Enabled frequencies are controlled using channel mask. Leave it blank means using

all the default standard usable channels specified in the LoRaWAN® regional parameters document. A bit in the Channel Mask field set to 1 means that the corresponding channel can be used for uplink transmissions if this channel allows the data rate

currently used by the end-device. A bit set to 0 means the corresponding channels

should be avoided.This option is optional for CN470, US915 and AU915.

Radio Channel Settings

Center Frequency of Radio 0

Supports transmitting and receiving packet;

Note: For details of default value and configuration ranges in different regions, please refer to Milesight Troubleshooting-5G AIoT Camera.

Center Frequency of Radio 1

Only supports receiving packet from nodes;

Note: For details of default value and configuration ranges in different regions, please refer to Milesight Troubleshooting-5G AIoT Camera..

Multi-channel list

The radio and frequency corresponding to all channels will be listed here. All channels are enabled by default. You can also check the box to enable the corresponding channel.

LoRa Channel Settings

Enable

Enable/Disable the LoRa Channel.

Radio

Choose Radio 0 or Radio 1 as center frequency.

Frequency

Enter the frequency of this channel.

For example:

  • The frequency range formula of US915 and AU915: Center frequency ±0.55;
  • The frequency range formula of other regions (except US915 and AU915): Center frequency ±0.4625;

For example, the center frequency is configured with 867.5, then the frequency range corresponding to each channel: 867.5-0.4625~867.5+0.4625.

Bandwidth

Enter the bandwidth of this channel. 125KHz, 250KHz and 500KHz are available. The default option is 250KHz;

Note: The default option is 500KHz for AU915 and US915.

Data Rate

From SF7 to SF12, the transmission rate decreases and the transmission distance increases. In general, the range of Data Rate is SF7 ~ SF12, the default value would be SF7. Only the default value of the Channel Plan AU915 and US915 is SF8.

FSK Channel Settings

Enable

Enable/Disable the FSK Channel.

Radio

Choose Radio 0 or Radio 1 as center frequency.

Frequency

Enter the frequency of this channel.

Bandwidth

Enter the bandwidth of this channel. 125KHz, 250KHz and 500KHz are available. The default option is 125KHz.

Note: The default option is 250KHz for AU915 and US915.

Data Rate

Enter the data rate. The Date Rate must be between 500~250000.
Note: The configurations here should be the same with those in End Device.