7.1.2 Arming Control

The VMS supports setting Disarm Plan to disable events temporarily at a specific time interval.

Step1: Select the Event Type, Arming Status, Camera and IoT Sensor, and click ;

Step2: Check the events, and clickbutton or click;

Step3: Set the specific time interval that you’d like to disable the events and click ;

Step4: If you need to restore the armed status, you can click ;

The meanings of the icons on the interface can be referred to the table below:

Table 1.
Icon	Function Introduction
Disarm Plan	Click icon to disarm plan
Edit Plan	click icon to change the time interval of the Disarm Plan.
Delete Plan	Click icon to delete the disarm plan.