Configure Time Parameters

This section describes how to configure time parameters.

Steps:
  1. In the main page, click System from the left navigation tree.
  2. In the Set the System Time area, configure the following parameters as needed.
    Parameters Description
    Time Zone Select the time zone for system synchronization.
    Daylight Saving Time Enable or disable Daylight Saving Time (DST).

    Start Time: Start time of the DST time range.

    End Time: End time of the DST time range.

    DST Bias: Specifies the offset value for advancing clock time during Daylight Saving Time periods.
  3. In the Synchronize Time area, perform the following operations as needed.
    1. Set Synchronize Mode to NTP Timing or Manual Timing as needed.
    2. Perform the following operations as needed.
      If Do
      If Synchronize Mode is set to NTP Timing
      1. In the Server Address area, enter the NTP server address and click .
      2. In the Time Interval area, enter the time synchronization interval between the device and the NTP server and click .
      If Synchronize Mode is set to Manual Timing
      1. In the Setting Time area, set the device time and click .
      2. In the Synchronize with your computer time area, click Synchronize to synchronize the device time with the computer system time.