Enhancement



The meanings of the items on Image page can be referred to the table below:

Table 1. Description of the buttons

Parameters

Function Introduction
IR Balance Mode

There is an option to turn On/Off the IR LED.

IR Balance Mode would avoid the problem of overexposure and darkness, and the IR LED will change according to the actual illumination.
Defog Mode

Better image effect in foggy weather.
Reduce Motion Blur

Enable this function to reduce the motion blur of objects effectively.

You can adjust the deblur level from 1 to 100.
Digital Image Stabilisation

Decrease the blur and shakiness of the image.
White Balance

To restore white objects, removed color distortion caused by the light of the environment

Auto White Balance:This option will automatically enable the White Balance function

Manual White Balance: This option is only for H.265 series. Set Red Gain Level and Blue Gain Level manually.

Incandescent Lamp: Select this option when light is similar with incandescent lamp

Warm Light Lamp: Select this option when light is similar with warm light lamp

Natural Light: Select this option when there is no other light but natural light

Fluorescent Lamp: Select this option when light is similar with Fluorescent Lamp

Schedule mode: Select this option that you can customize the schedule to enable/disable above modes
Exposure Mode

Auto Mode, Manual Mode and Schedule Mode are available.

Auto Mode: The camera will adjust the brightness according to the light environment automatically;

Manual Mode: The camera will adjust the brightness according to the value you set, you can set the exposure time from 1~1/100000s, the higher the value is, the brighter the image is;

Schedule Mode: You can customize the schedule to enable/disable Auto Mode and Manual Mode.
BLC/WDR/HLC Mode

Single Mode: Set single mode for BLC/WDR/HLC.

Day/Night Mode: Support BLC/WDR/HLC on Day Enhancement Mode/Night Enhancement Mode separately.

Schedule Mode: Set schedule mode for BLC/WDR/HLC.
BLC Region

Off, Customize, and Centre are available (in single mode, only enable when WDR is disable)

Off: Calculate the full range of view and offer appropriate light compensation

Customize: This option enables you to customize inclusive or exclusive region manually

Centre: This option will automatically add an inclusive region in the middle of the window and give the necessary light compensation

Note: If you choose other display modes of fisheye under Multi-channel or Bundle-Stream mode except display mode with Original view, then you can not set the option.
Wide Dynamic Range

This function which can capture and display both bright and dark areas in the same frame enables details of objects in both bright and dark areas to be visible.

Off: Disable WDR function

On: Enable the WDR, there are three levels of Low/High/Auto

Customize: Customize the schedule to enable/disable the WDR function and set the levels with Low/High/Auto
Wide Dynamic Level

Set WDR with Low/High/Auto level
Anti-flicker Level

Reduce flickers that appear on screen in some lighting conditions and there are 10 levels of anti-flicker adjustments
High Light Compensation

This function is only for H.265 series to adjust the brightness to a normal range when the light is strong, refers to Figure 4-4-11

Off: Disable HLC function

General Mode: Enable the general mode of HLC, and there is a setting for HLC Level

Enhanced Mode: Enable the enhanced mode of HLC, and there is a setting for HLC Level
HLC Level

Select level for HLC
Day Enhancement Mode

BLC/WDR/HLC are available.
Night Enhancement Mode

BLC/WDR/HLC are available.