Home
Operation Guide
Maintenance
Upgrade
This chapter describes the steps to upgrade the device via ToolBox software.

Preface
Product Introduction
Hardware Introduction
Operation Guide
- ToolBox Configuration Guide
  This chapter describe the steps to quickly configure this device to set up the connection with LoRaWAN^® gateway and network server. If you require more advanced settings, please refer to the operation guide chapter.
- LoRaWAN^® Settings
  LoRaWAN settings are used for configuring the transmission parameters in LoRaWAN^® network.
- Time Settings
- General Settings
  General settings include the basic parameters of the device.
- RS485 Settings
  UC100 supports to set up communications with RS485 via two ways: Modbus channels or Modbus RS485 bridge LoRaWAN^®.
- IF-THEN Command
- Milesight D2D Settings
- Maintenance
  - Upgrade
    This chapter describes the steps to upgrade the device via ToolBox software.
  - Backup and Restore
    This device supports configuration backup for easy and quick device configuration bulk. Backup and restore are allowed only for devices with the same model and frequency band.
  - Reset to Factory Default
Installation
Uplink and Downlink
Services

Upgrade

This chapter describes the steps to upgrade the device via ToolBox software.

1. Download firmware from Milesight website to your PC.

2. Go to Maintenance > Upgrade, click Browse to import firmware and upgrade the device.

Note: Any operation on ToolBox is not allowed during upgrading, otherwise the upgrading will be interrupted, or even the device will break down.